Pneumatic quick joint

2016-06-08

type
According to the structure can be divided into:

 

1, open and close at both ends:
Do not link -- when the parent ring to the other side, stainless steel beads automatic roll out, sub body due to maternal and child body valve spring force, force operation and disconnect, child and maternal valve their closure instantly blocking fluid flow.
Link, when the body is inserted into the maternal, ferrule under the action of the spring back to its original position, the steel ball rolling lock tight sub body closely connected, and maternal and child body valve promote each other and open and fluid circulation and O-ring can completely block the fluid leakage.


2, both ends of the open type
Do not link -- when the parent ring is pushed to the other side, the steel ball automatic roll out. Therefore, sub body is removed from the; the daughter and the mother is no valves, fluid flowing out.
Link - when the body is inserted into the parent, the ring is the spring force to the previous position caused by steel ball locking, fluid flow, and the O-shaped ring to prevent leakage
3, single way open and close type
Do not link, when the parent ring to the other side, the stainless steel beads automatic roll out, progeny were open valve spring counterforce bomb, valve can automatically shut down to block fluid flow.
Link: when insert rings of the maternal side, the valve is opened to cause fluid flow, the gasket is the force of the spring to push back the original position, stainless steel beads will lock to ensure that the child / parent connection, inside the washer can completely block the fluid leakage.


Scope of application
The air pipe, air compressor, air drilling, grinding machine, impact wrench, screwdriver and other pneumatic tools connected with a quick connector
matters needing attention


L please do not use for quick fluid couplings other than the use of.
L please do not apply to fluid other than fluid.
L please do not connect with other company's fast fluid connections.
L do not use more than the maximum use of pressure.
L do not use outside of the temperature range to prevent wear or leakage of the seal material.
L do not carry on the artificial impact, bending, stretching, to prevent damage.
L do not mix in the metal powder or dust and other places to use, to prevent the work caused by bad or leakage.
L such as attachments will cause a bad job or leakage.
L do not remove the quick connector.

 

Pneumatic connector manufacturers:Ningbo Lida Pneumatic Complete Sets Co.,Ltd.