Five mounting methods for standard cylinders

There are many ways to install the cylinder. According to whether the cylinder can be moved after the cylinder is installed, it can be briefly divided into fixed type and swing type. In general, there are many installation forms for the same cylinder. There are Five mounting methods for standard cylinders:free type, tripod type, flange type, earring type and mid-swing type.

1. Free-type installation means that without using installation accessories, the thread in the cylinder body is screwed into the machine body for fixed installation; or the thread outside the cylinder body is used to fix the cylinder on the machine with a nut; The screw holes of the cover are screwed to the machine.

2. The tripod type installation method, denoted by LB, refers to using an L-shaped mounting tripod with the screw holes at the front end cover to install and fix it with screws. The mounting tripod can bear a large overturning moment and can be used for load When the direction of movement is the same as the axis of the piston rod.

3. Flange type installation can be divided into front flange type and rear flange type. The front flange type uses flanges and screws to fix the cylinder at the front end cover, and the rear flange type refers to the installation method at the rear end cover. It is also suitable for occasions where the direction of the load movement is consistent with the axis of the piston rod.

4. The earring type installation method is divided into single ear type and double ear type, which means that the cylinder end cover and the earring type installation accessories are fixed together with screws at the rear end cover of the SC series standard cylinder. The vertical direction of the piston rod axis has a The cylinder of the shaft pin hole, the load and the cylinder can swing around the pin shaft. During fast movements, the larger the swing angle, the greater the lateral load on the piston rod.

5. The installation method of the middle swing type is to install the TC middle swing in the middle of the cylinder to complete the installation and fixation of the cylinder. The cylinder of this installation method can swing around the middle trunnion, which is suitable for long cylinders.