-
Solenoid valve installation attention
Solenoid valve installation attention 1. When installing, it should be noted that the arrow on the valve body should be consistent with the flow direction of the medium. Do not install in places where there is direct dripping or splashing. The solenoid valve should be installed vertically upwards; 2...
May 24,2022 Industry News -
The difference between Pneumatic solenoid valve and electric valve
The difference between Pneumatic solenoid valve and electric valve 1. Switch form: The solenoid valve is driven by a coil and can only be opened or closed, and the action time is short when switching. The electric valve is generally driven by a motor. It takes a certain amount of time to complete th...
May 20,2022 Industry News -
Working principle of pneumatic control valve
Installation principle of pneumatic control valve: (1) The installation position of the pneumatic control valve is required to have a certain height from the ground, and there must be a certain space above and below the valve to facilitate the disassembly and repair of the valve. For regulating valv...
May 13,2022 Industry News -
What is the test procedure to verify the rated pressure of the filter regulator?
What is the test procedure to verify the rated pressure of the filter regulator? If only a single rated pressure is set for the entire product, this test shall be carried out on 3 random samples; if the input and output parts are respectively set with their respective rated pressure values, 6 random...
May 06,2022 Industry News -
What is the principle of Pneumatic Control Solenoid Valve sealing
The requirements for the sealing performance of the Pneumatic Control Solenoid Valve should be based on the prevention of leakage. According to the different parts and degrees of its leakage, the leakage of the Pneumatic Control Solenoid Valve is different. Therefore, different leakage prevention me...
Apr 28,2022 Industry News -
What is the repair method for cylinder leakage?
What is the repair method for cylinder leakage? There is internal leakage in the cylinder, and the leaking part cannot be seen from the outside, but the thrust (or pulling force) of the cylinder is insufficient. Disconnect the exhaust port to check that there is air discharge, check and replace the ...
Apr 23,2022 Industry News
Copyright © Ningbo Lida Pneumatic Complete Co., Ltd. Rights Reserved.
